8
8 Select “Choose the updated driver (Recommended)” and continue to click
Next at each dialog until the driver files are copied.
9 When Windows has finished copying drivers, click Close and restart your
system.
NOTE
: For troubleshooting information, see the section
Windows Troubleshoot-
ing
earlier in this guide.
Windows NT Automatic Configuration
PCI computers automatically detect and configure PCI-compliant adapters
while booting. The adapter IRQ level and I/O address are automatically set by
the BIOS each time you start your computer.
Start your computer to automatically configure the adapter. Configuration is
complete when Windows NT starts or when the DOS prompt appears.
If your computer displays an error while booting, it may require additional steps
to configure. See the section PCI Installation Tips later in this guide for more
information.
Windows NT Version 4.0 Only
After putting the adapter in the computer, connecting the cables and starting
Windows NT, you need to install the correct drivers.
1 Double-click the Network icon in the Control Panel.
2 Click the Adapters tab.
3 Click Add. You’ll see a list of adapters.
4 Don’t select an adapter from this list. Instead, insert the PRO/100+ adapter
disk or CD into the appropriate drive and click Have Disk.
5 Specify the appropriate drive in the dialog box and click OK. Then follow
the prompts to complete installation. When the adapter is added you’ll see
a new adapter listed in the Network adapters list.
6 Click Close to finish.
7 Restart Windows NT when prompted.
Windows NT Version 3.51 Only
After putting the adapter in the computer, connecting the cables and starting
Windows NT, you need to install the correct drivers.
1 Double-click the Network icon in the Control Panel.
2 Click Add Adapter.
3 When the list of adapters appears, scroll to the end of the list and select
<Other> Requires disk from manufacturer and then click Continue.
4 Insert the PRO/100+ adapter disk or CD in the appropriate drive, specify
that drive, and click OK.
P100se~2.fm Page 8 Tuesday, January 5, 1999 10:03 AM
To Next Page
Loading...
