21
Troubleshooting Boot Agent
If you do not see the message “ Initializing Intel PRO/100+ Boot Agent Version
2.0”, check the following;
In the computer setup, check for the boot device sequence. If “Intel PRO/100+
Boot Agent” or “Network” is listed, move it ahead of the hard drive in the boot
sequence.
Some computers require manual intervention to execute the Boot Agent. Look
for an informational note on the computer monitor after power-on that may
instruct you on executing a network boot. For example, some Compaq
computers will display the message “F12 Network Service Boot” on the
Compaq banner screen.
Adapter Specifications
Compatibility PCI v2.2 systems
Media (cable) Connectors and Wiring RJ45
Use Category 5 cabling at 100 Mbps
Supports 100BASE TX Fast Ethernet
Data Rate Mode 10 or 100 Mbps
Interrupt Levels PCI: INTA
Power Requirements 1.06 Watts @ 5.0VDC
Isolation Voltage 200V RMS
Operating Temperature 0 - 55 degrees C
Humidity 10% - 90% non-condensing
Diagnostic LEDs Activity/Link, 100 Mbps
Diagnostic Software On-board
PROSet, Setup
Responder
Compliance & Certification • Safety — UL
• FCC Class B
• CE & Immunity
• C-tick (Australian)
P100se~2.fm Page 21 Tuesday, January 5, 1999 10:04 AM
To Next Page
Loading...
