10
If your computer displays an error while booting, it may require additional steps
to configure a PCI adapter. See PCI Installation Tips later in this guide for more
information.
Run Setup to Install Network Drivers
Setup can automatically install NetWare DOS ODI client drivers for you or
display a readme file with installation instructions for other NOS drivers.
1 If your computer already has network drivers installed, restart the computer
without loading them. If the drivers are loaded from the AUTOEXEC.BAT
or CONFIG.SYS file, type REM in front of each line that loads a network
driver. Or, with DOS 6.x or later press F5 as DOS starts, to bypass the
drivers.
2 Insert the PRO/100+ adapter disk in a drive, switch to that drive, and at the
DOS prompt, type SETUP and press Enter.
3 Select the adapter from the menu.
4 Select Automatic Setup from the Main menu. Then follow the instructions
on the screen. If you want to test the adapter with a responder on the net-
work, see the Responder Testing on the Network (Optional) section later in
this guide.
Setup displays the adapter’s configuration and then runs a series of diag-
nostic tests that make sure the adapter and network are functioning prop-
erly. If Setup finds a problem, it displays the results and some possible
solutions.
5 When Setup finishes the tests, you’ll see the Install Network Drivers
screen.
6 Select the driver you want to install. Setup can install a NetWare client
driver for you. If you want to install other drivers, Setup displays a readme
file with installation instructions.
To set duplexing options, see the Duplex Mode (Optional) section later in this
guide.
P100se~2.fm Page 10 Tuesday, January 5, 1999 10:03 AM
To Next Page
Loading...
