DETERMINATION OF SOLID DENSITY FOR BALANCES WITH
PROPER OPTIONAL SOFTWARE *
Balance program allows to determine solid density through four steps:
TARE IN AIR;
TARE IN WATER;
SOLID WEIGHING IN AIR;
SOLID WEIGHING IN WATER.
STORAGE OF TARE IN AIR
Tare in air (weight of the small basket in air) is about zeroing of small basket weight in air.
Press TARE key to effect this operation being sure that value displayed is “0”.
STORAGE OF TARE IN WATER
Select density menu by pressing MENU key. The message “DENS” is displayed. By
pressing TARE key the message “t.H20” is displayed. Dip the small basket in water and
press TARE key once again. The message starts flashing until stability is reached, then an
acoustic alarm is given out. Tare value in water is stored until balance is switched off, and it
can be changed repeating the same sequence of operations above mentioned.
DETERMINATION OF SOLID DENSITY
Select “DENS” by pressing MENU key and then press CAL key. The message “S.AIR” will
be displayed. Load a solid in the small basket and press CAL key. The message starts
flashing. As soon as it is stable, an acoustic alarm is given out and the message “S.H2O” is
displayed. Dip the small basket with the solid in water and press CAL key once again. The
message will flash. As soon as stability is reached, an acoustic alarm is given out and
density value is displayed.
Press MENU key to return to weight display.
Press PRINT key to print the value displayed.
* Not
available for all models
To Next Page
Loading...
Need help?
General
