Intelligent Weighing Technology intell-lab ph series - Page 40

40
ATTENTION
When the balance is in over range condition, weight value transmitted is replaced by
strings “over” and “under” (only if PC output has been selected).
5) Connecting balance to PC
For connecting balance to PC, use connector 1 on the rear side of the balance as shown in
the following figure :
6) Connecting balance to serial printer To print weight, connect connector 1 of the
balance to serial printer as shown below :
Balance 2 Input data
Busy signal
Side
4
Printer
Connector
Side
5
GND
7) Connecting balance to optional keyboard
C
o
nnector 1, used for connection to PC, can also be used for possible connection to
Balance
Side
Connector 1
2
3
5
6
4
3 2
7 6
20
PC
Side
25 Poles
Balance
Side
Connector 1
PC
Side
9 Poles
2
3
5
6
4
2
3
5
6
4