IntelliTech International, Inc. Programmer’s Guide | 1
21 Thermal Printer Programmer’s Guide
• Internal media setup files
After reset the touchscreen calibration procedure will appear on the display. In addition,
the services Telnet and SSH will default to on and NTP (Network Time Protocol) will
default to off.
PJL INFO Read-Back Command
A sample command is as follows:
<ESC>%-12345X@PJL INFO xxx <LF>
@PJL EOJ <LF>
<ESC>%-12345X
“xxx” is the desired parameter as noted below:
Table 10: PJL INFO Read-Back Command Parameters
The following is a sample DATETIME response:
@PJL INFO DATETIME
Wed Jan 4 10:53:44 EST 2012
The following is a sample SENSORS response:
@PJL INFO SENSORS
HEADTEMP=265;
HEADVOLTAGE=271;
HEADPRESSURE=7;
RIBBONLEVEL=0;
REWINDERLEVEL=0;
HEADUP=0;
HEADUNLATCHED=0;
PRESENTSENSOR=0;
CUTTERHOME=0;
COVEROPEN=1;
HEADTEMPADC=226;
HEADVOLTAGEADC=211;
TOFADC=190;
Parameter Description
DATETIME
Returns the date and time from the printer.
SENSORS Returns value of system sensors.
SYSTEMSTATUS Returns system status
SYSTEMINFO Returns system info.
MEDIAFILES Returns list of internal media setup files.
SETUPFILES Returns list of internal user setup files.
LABELFILES Returns list of internal user labels files.
LANGUAGEFILES Returns list of language files.
To Next Page
Loading...
Need help?
General