IntelliTech International, Inc. Programmer’s Guide | 1
25 Thermal Printer Programmer’s Guide
<ESC>%-12345X@PJL JOB NAME = "JOB_CLEAN_INIT" <LF>
@PJL PERFORM HEADCLEANMODE = 1 <LF>
@PJL EOJ <LF>
The media should then be removed and a special cleaning card inserted. Issue the
PERFORM HEADCLEAN command:
<ESC>%-12345X@PJL JOB NAME = "JOB_CLEAN" <LF>
@PJL PERFORM HEADCLEAN <LF>
@PJL EOJ <LF>
When the cleaning is complete disable the head clean mode:
<ESC>%-12345X@PJL JOB NAME = "JOB_CLEAN_END" <LF>
@PJL PERFORM HEADCLEANMODE = 0 <LF>
@PJL EOJ <LF>
PJL Cutter, Rewinder, and Ribbon Assembly Self-Test Commands
Prior to performing self test procedures for options, the self test mode must be entered
as the following:
<ESC>%-12345X@PJL JOB NAME = "JOB_SELFTEST_INIT" <LF>
@PJL PERFORM SELFTEST = 1 <LF>
@PJL EOJ <LF>
For rewinder or ribbon assembly tests the media should be detached from the
mechanism. To perform the rewinder test, issue the following:
<ESC>%-12345X@PJL JOB NAME = "JOB_REWIND_TEST" <LF>
@PJL PERFORM REWIND <LF>
@PJL EOJ <LF>
Ribbon front and back assemblies can be tested using the PERFORM RIBBONFRONT
or RIBBONBACK commands, respectively.
For testing the cutter, insert a value for the number of cuts as seen below.
<ESC>%-12345X@PJL JOB NAME = "JOB_REWIND_TEST" <LF>
@PJL PERFORM CUT = n <LF>
@PJL EOJ <LF>
“n” is the number of cut cycles to perform.
View test results by using the PJL INFO SYSTEMSTATUS read-back command. The
value LASTLBLCNT is the total cycles requested and ERRORCOUNT is the number that
failed.
The PERFORM ABORTALL command is used to cancel ongoing tests. To re-test and
clear counters issue PERFORM SELFTEST = 2
When the self tests are complete the command below can be used to disable the self test
mode:
To Next Page
Loading...
Need help?
General