IntelliTech International, Inc. Programmer’s Guide | 1
23 Thermal Printer Programmer’s Guide
File3.stc
File4.stc
PJL JOB Command
The parameter “SECURITY” is used to allow changes to defaults for printer specific
items such as adjustments and media calibration values. The value of the SECURITY
parameter must match the printer’s security key to take effect.
The following is a sample command:
<ESC>%-12345X@PJL JOB SECURITY = “0x80395AC2” <LF>
@PJL DEFAULT HEADPRESSUREADJ = 5 <LF>
@PJL EOJ <LF>
PJL PERFORM Command
The custom PJL PERFORM command is used for various functions on the printer. PJL
password security in the JOB command is used to protect against unauthorized use of
this command. Please refer to the HP PCL/PJL Technical Reference Manual for more
information on PJL security.
The syntax of the command is as follows:
<ESC>%-12345X@PJL JOB NAME = "JOB_NAME" <LF>
@PJL PERFORM PARAMETER [= value] <LF>
@PJL EOJ <LF>
The value is optional as noted below:
Table 11: PJL PERFORM Command
Parameter Description Value Notes
DOTCHECK Performs a dotcheck
diagnostic on the print
head
Number of dots to
check. 0 for all
EMPTYCAL Performs empty
calibration.
N/A Media should be
removed prior to issue
ABORTALL Abort all current functions N/A
CAL Performs media
calibration
Distance in dots to
move
Media should be
loaded prior to issue
FEED Feeds media to next Top-
of-Form
N/A
HEADCLEAN Performs head clean
N/A
Must be in head clean
mode (See below)
MOVE Moves media a certain
distance
Distance in dots to
move
CUT Engage cutter Number of cut cycles
To Next Page
Loading...
Need help?
General