Start Box
Check that the following items
are in the Start Box:
• Inteno DG150v2
• Power adapter
• RJ45 Network cable WAN (red, large
contact)
• RJ11 DSL cable (grey, small contact)
Connecting the
DSL/telephone jack
It’s important to connect the broadband
service to the first telephone jack in your
home. Otherwise you may get trouble with
your telephony service, as well as your
data service. In an apartment you’ll usually
find the first telephone jack close to the
entrance door. In a villa, the location of the
jack may be harder to detect, as you need
to find out where the telephone cable
connects to the house. If you previously
have had a broadband service and it has
worked without troubles you’ll know that
you should install the modem in the same
telephone jack as before. If you haven’t
had a broadband service you’ll need to
localize the first telephone jack.
Do as follows:
1. Shut down your computer.
2. Connect the grey telephone cable to
the first telephone jack in your home.
3. Connect the other end of the grey
telephone cable to the DG150v2 (use
the DSL outlet).
If you have received a DSL splitter
adapter, connect it to the first telephone
jack. Then attach the grey telephone cable
from the DSL splitter to the DG150v2.
Connecting the WAN/
broadband connection
Do as follows:
1. Shut down your computer.
2. Connect a RJ45 network WAN cable
between your broadband outlet
and the DG150v2 WAN port (red,
labeled WAN).
To Next Page
Loading...
