PA-2000/PA-4000/PA-2000R/PA-4000R Public Address Amplifier
17. MEMORY Switch (PA-2000R/PA-4000R Only)
This switch, used in conjunction with the Address Select Switches (see 15 above),
is used for entering a selected radio frequency into one of the 16 preset locations.
To enter a frequency into memory:
• Select the desired frequency with the UP or DOWN switches (see 18 below)
• Select the A or B bank with the SHIFT switch (see 16 above)
• Press the MEMORY switch
• Press the Address Select switch for the desired location (see 15 above)
• The current frequency will be stored in the selected memory location
18. UP and DOWN Switches (PA-2000R/PA-4000R Only)
These switches are used to tune the radio frequencies to higher or lower
frequencies. Pressing the UP or DOWN switch once will move to the next available
frequency. Pressing and holding the UP or DOWN switch will tune the frequency
without stopping.
19. Radio Volume (PA-2000R/PA-4000R Only)
Controls the volume level of the radio tuner output.
9
To Next Page
Loading...
Need help?
General
