Interacoustics EyeSeeCam vHIT - Replacing Parts; The Silicone Tubes

Service manual
EyeSeeCam vHIT
5
2.2 Replacing parts
1
With the purpose of enabling replacement of certain parts of the EyeSeeCam google, this chapter contains a
disassembly guide for EyeSeeCam vHIT.
Disassembly should always be conducted by a technician authorized by Interacoustics.
2.2.1 The silicone tubes
This paragraph describes how the silicone tubes, covering the goggle frame, are replaced .
Figure 1
Slip one end of a silicone tube strip over a tip
on the frame, while pulling. Lay the strip
around the frame's edge, always maintaining
a certain pulling force.
Slip the other end
over the tip.
Figure
3
Press the strip into smooth position without
creases.
Repeat for the other side.
1
All illustrated items in this service manual are for instructional purposes only, and may differ in color, shape and similar.
NOTICE
Due to the fragility of the camera parts, disassembly
must be performed with utmost caution.
TOOLS
Phillips screwdriver 311 0x60
Stanley knife
Figure 2