2.8.5 Connecting the printer to the Titan via Bluetooth
Pairing the printer to the Titan is necessary before printing via Bluetooth is possible.
Follow these instructions to pair the printer:
1. Turn the printer on by holding down the power button for 2 seconds.
2. On the Titan hand held unit, go to My Titan | Printer and press Search.
3. Let the instrument search for Bluetooth devices. This may take up to 1 minute.
4. A device called MPT-II should appear in the list of devices.
5. Press Select to finish pairing.
If you want to print out measured results on a Bluetooth connected thermal printer it is recommended to
switch on the printer before doing the measurements. This will allow the printer enough time to connect and
be ready for printing when measurements are completed.
To Next Page
Loading...
