Titan Instructions for Use - EN Page 27
Software Installation
To know before you Start Installation
You must have administrative rights to the computer on which you are installing the Titan Suite.
Important note on the use of Normative Data
You are about to install the Titan Suite software. Some parts of the software have normative data available
that can be displayed and compared to recordings made. If it is preferred not to display normative data,
these can be deselected in the test protocols in question or new alternative protocols without normative data
can be created and used.
Interacoustics claims no diagnostic consequence of degree of fit between the recorded results and whatever
normative data examples the operator chooses to bring forward for comparison.
Further information about the normative data can be obtained from the Titan Additional Information Manual
and from Interacoustics.
NOTICE
1. DO NOT connect the Titan hardware to the computer before the software has been installed!
2. Interacoustics will not make any guarantee to the functionality of the system if any other software is
installed, with exception of the Interacoustics OtoAccess™ or Noah 4.0 or higher.
PC minimum Requirements
• 2 GHz Dual Core CPU or better (Intel recommended)
• 1GB RAM or more (4GB recommended)
• Hard drive with min 10 GB free space (Solid State Drive (SSD) recommended)
• Minimum display resolution of 1024x768 pixels (1280x1024 or higher recommended)
• DirectX 9.0c compatible graphics (Intel/NVidia recommended)
• One or more USB ports, version 1.1 or higher
• DVD-ROM drive
Supported Operating Systems
• Microsoft Windows
®
7 32-bit and 64-bit
• Microsoft Windows
®
8 32-bit and 64-bit
• Microsoft Windows
®
10 32-bit and 64-bit
Windows
®
is a registered trademark of Microsoft Corporation in the United States and other countries.
Important: make sure you have the latest service packs and critical updates installed for the version of
Windows
®
that you are running.
What you will need:
1. Titan Suite Installation DVD.
2. USB Cable.
3. Titan Hardware.
To use the software in conjunction with a database (e.g. Noah 4 or OtoAccess
TM
), make sure the database is
installed prior to the Titan Suite installation. Follow the manufacturer’s installation instructions provided to
install the relevant database.
Note that if you are using AuditBase System 5 you must ensure to launch this office system prior to this
installation of the Titan Suite.
To Next Page
Loading...
