Interacoustics Titan - Page 98

Titan Instructions for Use - EN Page 94
General
PC control
USB:
Input/output for computer communication. Titan can be fully operated
from a PC. The measurements can then be followed on the PC
screen.
Data can be sent to and saved on the PC and stored in OtoAccess™.
See separate section in Service Manual for programming details.
Memory
Theoretically, an infinite amount of test results can be stored on the
PC. The Titan hand held unit is delivered with a 8 GB memory card,
enough for storing more than a quarter of a million tests.
Thermal printer (Optional)
Type:
Thermal (Bluetooth) printer with recording paper in rolls. Print on
command through Bluetooth communication and through serial RS-
232.
Paper width:
57.5 ± 0.5 mm on thermal printer
Printing time:
Printing time depends on the size of the used protocol. For 2
tympanograms and 8 reflexes the thermal printer uses approximately
6s.
Dimensions
6 x 6 x 28 cm / 2.4 x2.4 x11 inches
Titan Weight
360 g / 0.8 lbs
ABR/OAE/IMP
PreAmplifier weight
120 g / 0.26 lbs
ABR/OAE/IMP
PreAmplifier dimensions
10.2 x 6.8 x 2.6 cm / 4 x 2.7 x 1 inches
OAE/IMP shoulder box
weight
64 g / 0.14lbs
OAE/IMP shoulder box
dimensions
6.5 x 3.5 x 1.8 cm / 2.6 x 1.4 x 0.7 inches