Interchange SN5016 - Methods of Operation

16 Ga. Medium Crown Stapler
Drives 7/16" Crown Staples (1" to 2" / 25 to 51mm)
Model No. SN5016
Item No. 64405
12
Interchange Brands Operator’s Manual
Operating The Stapler
DANGER: Operators and others in work area must wear safety
glasses with side shields. Eye protection equipment must conform
to the requirements of American National Standards Institute, ANSI
Z87.1.
Read and understand METHODS OF OPERATION below.
Methods of Operation
Explanation of the choice of triggering methods (on some models)
This stapler is equipped with the safety/push lever and does not operate unless the
safety/push lever is depressed (upward position).
There are two methods of operation to drive staples with this Stapler
■ Single Fire
 The switch location is shown in
the illustration at the right.
For single fire operation, depress
the contact arm against the work
surface and pull the trigger. Tool
cannot fire a second staple until
the trigger is released and tool
can cycle.
■ Bump Fire (Multi-Fire)
 The switch location is shown in
the illustration at the right.
For bump fire operation, hold the
trigger and depress the contact
arm against the work surface.
Turn Switch
to the right
for single fire
operation.
Switch
Turn Switch
to the left for
bump fire
operation.
Trigger