PW800, Users
Rev O, January, 2008
10
SCALE SELECT
Reserved for future use.
UNDER
Reserved for future use.
Power/Batteries
To change batteries:
1. Loosen the two "quarter-turn" connectors on the back of the control box.
2. Pull the cover back and change the cells, being careful to note battery orientation.
3. Replace the cover and tighten the quarter-turn connectors.
Warning: If you have the optional charger, do not plug the charger in while there
are standard ‘D’ cells inside. This could result in damage to the batteries and
your scale.
The typical recharge time for Ni-cad cells is 16 hours. The rechargeable batteries have a life
span up to 1000 cycles.
To Next Page
Loading...
