Interlogix Concord 4 - Page 56

54 Concord 4 User Manual
To operate your system using a touchtone phone:
1. Use a touchtone phone to access the system.
Local phone access. Pick up the phone. Within 5 seconds of picking up the
phone receiver, enter # (or *).
Remote phone access. Use the ring-hang-ring or twelve-ring method to get
the system, then enter # (or*), code.
2. Enter the system command as shown in Table 10 below.
Table 10: System commands
Command
Entry
Disarm the system
Press #, 1, code.
Arm to Level 2
Press #, 2, code.
Arm to Level 3
Press #, 3, code.
Send a police panic alarm
Press *, *, *, *, *, * (available from onsite only).
Arm system with no delay
Press #, 2, code,4 (Level 2), or press #, 3, code, 4 (Level 3).
Arm to enable latchkey
Press #, 2, code, 6 (Level 2), or press #, 3, code, 6 (Level
3).
Arm system exit lights off
Press #, 2, code, 0 (Level 2), or press #, 3, code, 0 (Level
3).
Bypass a sensor
Indirectly: Arm the system and then press #, #.
Directly: Press #, #, code, sensor number
Arm silently
1
Press #, 5, 2, code (Level 2), or press #, 5, 3, code (Level
3).
Turn all lights on/off
Press #, 0, 0.
Turn specific lights on/off
Press #, 0, light number (1 to 9).
Cancel an accidental alarm
Press #, 1, code, or press #, code.
Check the system status
Short status: Press #, *.
Full status: Press #, *, *.
Turn chime on/off
Press #, 7, 1.
Turn energy saver on/off
Press #, 7, 2.
Disable local phone access
Press #, 7, 3 (onsite only), or wait 5 seconds after picking
up a local phone.
Check alarm memory
Press #, 7, 6.
Activate outputs
Press #, 7, 6, output number (1 to 6).
1. If the quick arm feature is on, access code is not required.