Interlogix TruVision NVR 22 - Page 59

Chapter 9: Display settings
TruVision NVR 22 (S/P) User Manual 53
Figure 19: Display Settings window
Table 10: Description of the Display setup window
Option Description
1.
BNC Output Standard
Define the desired output mode. The BNC output can be used as event
monitor and also produces the image that is used for the V-stream.
Select one of the options from the drop-down list: PAL or NTSC, and
click Apply.
2.
Picture Setting
Define the desired output mode.
Select one of the options from the drop-down list: Standard, Bright, Soft,
or Vivid, and click Apply.
3.
BNC Output Brightness
Define the desired brightness by using the slider.
4.
VGA
Resolution Define the resolution of the selected monitor.
Select one of the options from the drop-down list and click Apply. The
selected resolution must be the same as that of the monitor.
5.
HDMI Resolution
Define the resolution of the selected monitor.
The resolution can be up to
4K.
Select one of the options from the drop-down list and click Apply. The
selected resolution must be the same as that of the monitor.
6.
Display Status Icons
Define whether the status icons are displayed. Default is Enable.
7.
Time
Bar Transparent Select the transparency of the monitor output time bar on screen relative
to the background to make the time bar easier to read.
Check the box to enable/disable. Default is Disable.
8.
Enable Time
bar Select whether the monitor output time bar appears on screen.
Check the box to enable/disable. Default is Enable.
9.
Time Bar Size
Select the size of the time bar: Large, Medium, or Small. Default is
Large.