18 Installation Guide
To add the camera to the local network via the network
cable (Ethernet):
1. Connect the camera to the local router using the CAT5
cable.
2. For outdoor applications, use the included water joint to
protect the connection on the camera side.
3. Provide power to the camera using POE (Power over
Ethernet), the included transformer, or an external
transformer using the included DC plug.
- Or -
To access the camera via a Wi-Fi network (non-WPS,
Ad-Hoc mode):
1. Power up the camera.
2. From your computer, search for the SSID that was set up
for the camera for Ad-Hoc mode. Select the SSID to
connect the camera.
To Next Page
Loading...
