Installation Guide 23
Add the camera to UltraConnect
The camera hardware must be correctly installed before
proceeding to set up the camera.
Ensure that the camera and ZeroWire panel are on the same
local area network. Applications where the ZeroWire panel uses
cellular only are not compatible with this camera.
Note: For detailed information on how to setup the
UltraConnect app, add locations, and log in as an installer,
please refer to the ZeroWire installation guide.
To add the camera to UltraConnect:
1. From your iOS or Android device, open the UltraConnect
App and log in to the site as the installer.
2. Click More on the bottom of the screen, then Settings.
3. Select Cameras under “Settings Selector”.
4. Click Scan for New Cameras.
5. A “Success!” message will pop-up after a few moments.
To Next Page
Loading...
