UltraView PTZ
User Manual
10
Auto Return
Set the camera to automatically return to an activity after a period
of inactivity, to a home position (preset 000), a specific preset, a
preprogrammed tour, or autopan mode (Figure 12). This feature
is disabled by default.
• To disable the autoreturn feature, select option 1. Default
is Disable.
• To automatically return to the home position (preset 000),
select option 2.
• To automatically return to a preset position, select option
3, press iris +, and choose the preset to return to.
• To automatically return to a preprogrammed tour, select
option 4, press iris +, and choose the preprogrammed
tour you want to return to.
• To automatically return to autopan, select option 5.
Figure 12.Autoreturn menu
If you choose to autoreturn to a certain setting, set the period of
inactivity (return time) referenced in the Autoreturn menu
(Figure 13). Access the time selection option by pressing the
joystick after selecting any option other than Disable.
The minimum return time is 15 seconds. The maximum return
time is 60 minutes. Use the joystick to increase or decrease the
return time for items 2 through 5 in the following increments:
• Increments of fifteen seconds to increase the return time
from 15 to 60 seconds.
• Increments of one minute to increase the return time from
one to ten minutes.
• Increments of five minutes to increase the return time
from ten to 60 minutes.
Figure 13.Autoreturn timer
Azimuth indicator
Enable a direction indicator to be displayed on the monitor/screen
(Figure 14).
• To disable the azimuth indicator select option 1.
(The default setting is 1, Disable.)
Figure 14.Azimuth indicator menu
To Next Page
Loading...
