Chapter 1
Programming
11
• To enable the azimuth indicator to show the heading (N,
NE, E, SE, S, SW, W, or NW), select option 2 and use the
joystick to move through the heading options
(Figure 15).
Figure 15.Azimuth indicator menu: Set heading
• To enable azimuth indicator to show the pan, tilt, and
zoom coordinates, select option 3 and use the joystick to
select numerical settings for P (pan), T (tilt), and Z
(zoom) (Figure 16).
Figure 16.Azimuth indicator menu: Set coordinates
To calibrate the indicator (Figure 17), do the following:
1. Select set north, and press iris +.
2. Move to the desired position for north and press the iris +
button. Press the iris - button to cancel.
Figure 17.Azimuth indicator: Set north
To set where on the screen/display the indicator displays
(Figure 18), do the following:
1. Select display row, and press iris +.
2. Set the row between 01 (the heading default) and 11 (the
NTSC coordinate default; 14 is the default for PAL) by
using the joystick to navigate to the desired number and
press iris +.
Figure 18.Azimuth indicator: Display row option
To Next Page
Loading...
