Intermatic PE1501RC - Clock Programming; Setting Time of Day; Programming ON;OFF Settings

Four: Programming the Clock 21
Providing a brighter solution.™
Section 4:
Programming the Clock
Overview
There are two revisions of the upper and lower control boards.
The difference between these two revisions is the relay the
Pump Timer controls.
On System Rev. #1, the Pump Timer controls Relay #2.
On System Rev. #2, the Pump Timer controls Relay #1.
Please check to see which revision you have and connect your
pool/spa equipment accordingly. You should connect your
Filter Pump to the relay controlled by this timer so that you
can program ON and OFF times for your lter pump cycle.
An additional clock can be installed in the steel enclosure if
desired, providing timer control of a second relay. The second
relay will control relay #5 (System Rev. #1) or Relay #4 (System Rev. #2). See page 8 for ordering
and installation procedure.
The clock can be programmed for up to eight ON/OFF settings.
Setting Time of Day
Press and hold the CLOCK button.
Press the HOUR button to advance the clock to the correct hour of the day. Repeat with the
MIN button.
NOTE: Take care to observe correct AM and PM settings.
Release the CLOCK button when nished. The time is now set.
Programming ON/OFF Settings
Press the TIMER button to enter the rst ON time. The clock screen displays the the number
“1” and the word ON, indicating that it is ready for you to set the ON time for the rst setting.
NOTE: If previous ON/OFF settings have been programmed, the clock will display them, and
your new programming will revise them. If the clock has not been programmed before, the
screen will display “__ __ : __ __” as you begin the programming procedure.
Press the HOUR button to advance the clock to the ON time you want to set, followed by the
pressing the MIN button to complete the time setting.
NOTE: Take care to observe correct AM and PM settings.
Press the TIMER button a second time to enter the OFF time for the setting. The clock screen
displays the number “1” and the word OFF, indicating that it is ready for you to set the OFF
time for the rst setting.
•
•
1.
2.
3.
1.
2.
3.