30 Mini-Wave PE4 Installation Guide
Copyright © 2006 Intermatic, Inc.
Push the black button on the base of the Panel-Mounted Transceiver.
The screen returns to the full screen with the word SUCCESS at the
bottom, as shown.
Press the <2> function button to select ADD TO GROUP. The screen
refreshes and displays only the line 2 ADD TO GROUP.
Push the black button on the base of the Panel-Mounted Transceiver.
The screen returns to the full screen with the word SUCCESS at the
bottom, as shown.
Press the <CHLR> button on the Hand-Held Remote to exit
programming mode. On the left side of the screen, you will see the
words STAT OK.
The two devices are now linked together within the network you have
installed.
NOTE: If the two devices have not successfully reset or linked together — and you are seeing only
the word STAT on the left side of the screen — it’s likely that old programming still exists in either
device. Carefully repeat the two procedures Deleting Any Existing Programming (on page 28)
and Linking the Hand-Held Remote to the Receiver (on page 29). If the problem persists, contact
Intermatic Customer Service.
Testing Mini-Wave Reception
At the heart of the Mini-Wave system is Z-wave™ wireless technology.
Test reception by walking around the yard with the Hand-Held Remote
and look on the screen to see if there are any areas where STAT OK
changes to STAT (which means the Hand-Held and the Control Center
are no longer communicating).
Signal reception between Hand-Held Controllers and the Control Center is affected by distance
(about 100 feet, direct line of sight) and by physical obstacles (like brick, wire lash in walls, or
steel structures).
If you identify any locations in the area of operation where communications problems occur —
typically when a steel structure blocks the line of sight between the Hand-Held and the Control
Center, install the 35-ft. Antenna Extension Cable (PA121) to relocate the antenna from the
Panel-Mounted Transceiver into the area of operation.
4.
5.
6.
7.
LEAR N VER x
1 INC LUDE NOD E
2 ADD TO GROUP
3 RES ET N ODE
4 RES ET C ONTROLLER
5 MOR E OP TION S
C EXI T
SUC CESS
LEAR N VER x
1 INC LUDE NOD E
2 ADD TO GROUP
3 RES ET N ODE
4 RES ET C ONTROLLER
5 MOR E OP TION S
C EXI T
SUC CESS
LEAR N VER x
2 ADD TO GROUP
LEAR N VER x
2 ADD TO GROUP
LEAR N VER x
1 INC LUDE NOD E
2 ADD TO GROUP
3 RES ET N ODE
4 RES ET C ONTROLLER
5 MOR E OP TION S
C EXI T
SUC CESS
LEAR N VER x
1 INC LUDE NOD E
2 ADD TO GROUP
3 RES ET N ODE
4 RES ET C ONTROLLER
5 MOR E OP TION S
C EXI T
SUC CESS
STAT
OK
POOL
OO
ºF SET
P OO
S OO
STAT
OK
POOL
OO
ºF SET
P OO
S OO
Antenna Extension Cable
Assembly (PA121)
Antenna Extension Cable
Assembly (PA121)
To Next Page
Loading...