Intermatic PE1501RC - Section 5: Installing System Options; Installing a Booster;Cleaner Pump

Five: Installing System Options 23
Providing a brighter solution.™
Section 5:
Installing System Options
Installing a Booster/Cleaner Pump
When a Booster/Cleaner Pump must be controlled, you need to order and install the optional
Booster/Cleaner pump relay (PA120) in your Mini-Wave Control Center. In addition, you need
to program your PE950 Wireless Hand-Held Transceiver to lock out the Booster/Cleaner pump
whenever your valve actuators change from the pool position to the spa position. Refer to
page 36 for Programming to protect a Pool Cleaner Pump.)
NOTE: When installing the optional relay, you must purchase the PA120 Optional Relay Kit. This
relay must have a 24VAC coil, NOT A 24VDC COIL like the remaining four relays. If the 24VDC
coil relay is installed, the relay will chatter and could cause a failure of the pool or spa equipment.
Remove the Low Voltage Divider to gain access to the Relay Screws (See Figure 5-1.)
Remove the ller plate on the Low Voltage Divider by bending the plate back and forth until
the plate breaks off. (See Figure 5-1.)
Remove the two screws and install the Relay (PA120) with the same two screws. (See
Figure 5-1.)
Plug the 24VAC coil wires from the relay to any of the two available three-pin plugs on the
upper control board. (See Figure 5-2.)
Reinstall the Low Voltage Divider in your Master Control Center (See Figure 5-1.)
When installation is complete, button <3> on the Hand-Held Remote will operate the pump.
1.
2.
3.
4.
5.
6.
Figure 5-3Figure 5-3
Low Voltage
Divider
Filler Plate
PA120
Relay
120 VAC
Coil
Relay
Screws
Low Voltage
Divider
Filler Plate
PA120
Relay
120 VAC
Coil
Relay
Screws
Button <3>Button <3>
Upper Control
Board
24VAC Coil
Wires
Lower Control
Board
Upper Control
Board
24VAC Coil
Wires
Lower Control
Board
Figure 5-2Figure 5-2
Figure 5-1Figure 5-1