Intermatic PE1501RC - Installing a Firemans Switch or Second Timed Function

Five: Installing System Options 25
Providing a brighter solution.™
Installing a Fireman’s Switch or Second Timed Function
It may be necessary to have a Second Timed Function for a
particular piece of pool/spa equipment, or to provide a Cool-
Down Period for your heater prior to shutting off the pump.
(Consult the heater owner’s manual for this requirement.)
If any of these two features are desired, you must install a
second timer for this feature.
Preliminary Installation Steps
Order the PB313EK Timer Kit. (See page 8 of this manual.)
Remove ALL power from the Mini-Wave Control Panel.
Remove the Deadfront Cover from the panel. (See Figure 5-6.)
Remove the Cover Access Plate from the second timer hole on the Deadfront Cover. (See
Figure 5-6.)
Remove the Low-Voltage Divider to gain access to the Control Chassis Screws. (See Figure 5-7.)
Remove the screws that secure the Control Chassis. (See Figure 5-7.)
Install the second timer using the hardware provided with the PB313EK timer kit. Reference
the timer already installed if not sure how to install the second timer. (See Figure 5-7.)
Supply 120VAC to Terminals 1 and 2 of the pump timer. To simplify installation, tap into the
power supplying the rst timer. (See Figure 5-8.)
1.
2.
3.
4.
5.
6.
7.
8.
Deadfront Cover
Cover Access Plate
Deadfront Cover
Cover Access Plate
Figure 5-6Figure 5-6
Control
Chassis
Second
Timer
Low Voltage
Divider
Chassis
Screws
Chassis
Wire Access
Hole
Control
Chassis
Second
Timer
Low Voltage
Divider
Chassis
Screws
Chassis
Wire Access
Hole
Figure 5-7Figure 5-7