Intermec CK32

Chapter 4— Developing and Installing Applications
102 CK32 I-Safe Handheld Computer Users Manual
AutoCab Script Commands
Example:
; Install all cab files in the \Flash File Store\XYZ directory,
regardless.
AutoCab -FILE="\Flash File Store\XYZ\.cab" -FORCE
; Install only one cab file, use Intermec cab installation display
AutoCab -FILE=”\myCab\app.cab” =show=2
Command Description
-ChkRst= Set to 1 to configure AutoCab to check for the
Reset flag after all .cab files are installed. This file is
created by .cab files that want a clean reset after
installation. Default is 0 (do not check for flag).
-File= Specifies the .cab files to extract. Note that the
specified files need not end with the .cab extension.
-Force Forces the specified .cab files to extract regardless of
whether it was previously extracted.
-Log= Set to 1 to create a log file in the same folder that
AutoCab is running. Useful for debugging .cab
installation. Default is 0 (disabled).
-Move= Set to 1 to force source .cab file deletion, even
when read-only bit set on file. Default is 0
(disabled).
-Quiet= Set to 0 to allow AutoCab to display user message
box on errors. Useful for debugging .cab
installation. Default is 1 (keep quiet).
-Show= Set to 0 to prevent showing any installation
progress interfaces and also prevents canceling the
installation. Set to 1 to show normal installation.
Set to 2 to show Intermec installation progress
interface (user can see what is installing but cannot
cancel it). Default is 1 (show normal).
-Signal= Set to string name of signal to use at the
completion of .cab installation before a reboot
occurs (if enabled). AutoCab uses
WaitForSingleObject on this name. Default is
disabled.