Intermec CK32 - Configuring EAP-FAST with Profile Wizard

Chapter 3 — Configuring the CK32 I-Safe
76 CK32 I-Safe Handheld Computer User’s Manual
4 For Encryption, choose TKIP or AES if you selected WPA2
for association, or WEP or CKIP if you selected Network
EAP for association.
5 For Username, type a unique username for this protocol.
6 In the Password field, type a unique password for this
protocol.
7 Select Prompt for password to have the user enter this
password each time to access the protocol, or select Use
following password to use the protocol without entering a
password each time you use the CK32 I-Safe.
8 Tap OK.
Configuring EAP-FAST with Profile Wizard
The EAP-FAST protocol is a client-server security architecture
that encrypts EAP transactions with a TLS tunnel. While similar
to PEAP, EAP-FAST differs significantly since tunnel
establishment is based on strong secrets unique to users. These
secrets are called Protected Access Credentials (PACs), which
CiscoSecure ACS generates using a master key known only to
CicsoSecure ACS. EAP-FAST does not require certificate
management.
1 In the Profile Wizard, select the Security page.
2 For 8021x Security, choose EAP-FAST.
3 For Association, choose Open, WPA, WPA2, or Network
EAP.
4 For Encryption, choose WEP or CKIP if you selected
Network EAP for association.
5 For Username, type a unique username for this protocol.
6 In the Password field, type a unique password for this
protocol.
7 Select Prompt for password to have the user enter this
password each time to access the protocol, or select Use
following password to use the protocol without entering a
password each time you use the CK32 I-Safe.
8 Tap Additional Settings to set options for PAC management
and assign an anonymous EAP-FAST name.