Intermec EasyCoder 3400 Getting Started Guide

3440G.001
Power
Alert
Feed/Pause
Empty/Pause
1
2
3
4
6
5
7
Intermec Printer Install Tool
Version 1.1
Disk 1
EasyCoder
3400, 3440, and 3600 Printer
P/N 064678
Getting Started Guide
1 Intermec printer
2 AC power cord
3 PrintSet installation software disk
4 Ribbon core
5 Bar Code Label Printer Getting Started Guide
6 Media support (not shipped with 3600 printer)
7 Media envelope
Note: Make sure you remove all packing material from the printer before you proceed.
24
Power
Intermec
Alert
Feed/Pause
Empty/Pause
3440G.043
4
A
B
3
2
1
3440G.022
Power
Alert
Feed/Pause
Empty/Pause
Remove the media cover.
Locate the bias screw.
To compensate for uneven print quality, turn the bias
adjust screw as shown.
A If printing is light on right side of label, turn the
bias adjust screw counterclockwise.
B If printing is light on the left side of label, turn
the bias adjust screw clockwise.
Replace the media cover.
3440G.006
Power
Alert
Feed/Pause
Empty/Pause
1
Unpacking the Printer
Remove the accessories, packing material, and the printer from the shipping container. Save the
shipping container and packing materials in case you need to move or ship your printer.
Verify the contents of the shipping container against the list below:
Correcting Uneven Print Quality
You may experience problems in print quality (ribbon wrinkling or light print on one side of your
label) if the printhead is not making even contact with the label stock. You need a straight-slot
screwdriver to turn the bias adjust screw.
Note: To achieve the best print quality, adjust the bias adjust screw each time you use media of a different
width.
3440G.032
 AR RO WL E*
 AR RO WL E*

Intermec EasyCoder 3400 Specifications

General

Brand	Intermec
Model	EasyCoder 3400
Category	Printer
Language	English