To Next Page
P
payneoliviaAug 20, 2025
What to do if the media feed is not working properly on my Intermec Barcode Reader?
- Nnicole44Aug 20, 2025
If your Intermec Barcode Reader's media feed isn't working properly, there are several things you can check. If you've changed the media characteristics, perform a TEST-FEED. Ensure that the start- and stop adjust values, Media Type parameter and LSS position are correct; check and change them if necessary. Clean the media guides to remove any dirt from the sensors. If the sensors are faulty, they will need to be replaced.
General
