Chapter 2 — Configuring Network Settings
20 IF2 Network Reader User’s Manual
Configuring Settings for Your Network
You use the web browser interface to configure network settings. For
more information on using the web browser, see “Using the Web
Browser Interface” on page 10.
This chapter explains how to use the web browser interface to
configure settings for:
• wired Ethernet connections. For help, see the next section,
“Configuring Ethernet Settings.”
• parameters common to the wired connections, such as DNS
addresses and time servers. For help, see “Configuring Common
Network Settings” on page 23.
• network security, such as passwords and access methods. For help,
see “Configuring Security” on page 24.
• certificates. For help, see “Managing Certificates” on page 31.
From a device management standpoint, there are several other
methods you can use to configure network settings, including
Intermec SmartSystems and the Device Configuration web service.
For more information on using these methods to configure the IF2,
see Chapter 4, “Managing, Troubleshooting, and Upgrading the
IF2.”
Configuring Ethernet Settings
This section explains how to configure wired Ethernet settings using
the web browser interface.
If you are using a DHCP server, you may not need to configure
Ethernet settings. For more information, contact your network
administrator.
To Next Page
Loading...
Need help?
General