PB3 Mobile Printer User’s Guide 11
Printing a Configuration Test Page
Once the battery is charged and paper is loaded, you can print a
configuration test page. Use this information for reference when
installing the PB3 and to verify correct printer operation. If you
cannot print the test page, see “Troubleshooting” on page 19.
To print a test page
1 Make sure the printer is off before you begin.
2 Press and hold the Feed button.
3 Press the Power button once to turn on the printer. When the
printer starts printing the test page, release the Feed button.
4 To stop or cancel printing the test page, press either the Power or
Feed button.
Note: If you are using the AC adapter/charger as a power source, the
printer will not print unless a battery is installed.
To Next Page
Loading...
Need help?
General
