43
#1
LCD darkens in sunlight after Overexposed to sunlight - provide shading for display.
prolonged use.
Screen is full of noise, or has dots Reduce your gain setting and review the section on
running through it. interference.
Speed display is erratic. Check and clean the impeller wheel and the surrounding
area - be sure the impeller wheel spins freely.
Digital water depth not working. Increase your gain, and check that you are in the proper
depth range.
Factory Reset
READ THOROUGHLY BEFORE PROCEEDING
Start with the unit off.
1. Press soft keys #4 and #5 and hold (as labeled in diagram below).
2. Press the #6 key (power on/off).
The unit will turn on and beep three times, then release the keys. The Advantage logo with the picture
of a boat should appear in the display. This will reset the unit to its factory settings. Please refer to the Set-Up
View on page 24. If changes were previously made to the Language or Units of Measure.
#1
#4 #6 #5 #3 #2
LCD Display
To Next Page
Loading...
