Interquartz Gemini IQ333 - Unpacking; General Setting-Up; Corded Headset Installation; Headset Mic Adjust Control

18
UNPACKING
The carton contains the following:
● Telephonebodyandhandset
● Coiledcord,linecordandInterquartzEHSCable(forIQ333EHSonly)
● ThisUserManual
GENERAL SETTING-UP
1. Fit the COILED CORD to the appropriate sockets in the HANDSET and the telephone base.
2. Fit the LINE CORD to the rear socket and to your telephone network outlet
3. Set the Ringer Volume.
4. See following sections to complete the installation.
CORDED HEADSET INSTALLATION
Connect a headset to the headset socket at the rear, and set the HEADSET POLARITY SWITCH and HEADSET
MIC ADJUST CONTROL described in this section.
HEADSET MIC ADJUST CONTROL
This control allows many different headsets on the Australian market to function correctly with the telephone
byadjustingtheHEADSET'SMicrophonesensitivity.Thecontrolislocatedontheundersideofthetelephone.
Theadjustmentcanbemadebyasmallscrewdriverorsimilarimplementthatwilltintothecontrolslot.
To make a headset microphone level adjustment:
1. With the headset connected as per the instructions in this manual, put the headset on and lift the HANDSET
to your other ear and make an out-going call.
2. Pressing the HANDSFREE/HEADSET key, swap between HANDSET and HEADSET mode (the indicator
will illuminate when the HEADSET is in use) a few times while speaking to the other party.
3. With the other party's help decide if your voice level is the same when using the handset and headset.
Lastly, if you sound too loud on the headset, adjust the microphone sensitivity (turn anti-clockwise) so that
your voice level when using the HEADSET matches that of the HANDSET. Clockwise rotation increases the
HEADSET mic output level.
HEADSET POLARITY SWITCH
Located on the underside of the telephone, this switch provides compatibility with the two commonly-used
headset wiring standards.
• Corded Headsets: Position “V” suits Plantronics Vista Cords and other Headsets wired in the same
conguration(alsoknownas"reversed"wiringmode)
• CordedHeadsets:Position“P”suitsPlantronicsPcordsandotherHeadsets(includingthoseusing“smart”
cords)wiredinthesameconguration(alsoknownas"normal"wiringmode)
• WirelessHeadsets:todecidethecorrectpositionoftheswitch,pleaseconsulttheconnectiondiagramsin
theINSTALLATIONsectionorcheckwithInterquartzoranauthorisedreseller