Interquartz Gemini IQ333 - Multifunctional Indicator Light; Ringer Volume Switch; Alpha-Numeric Keypad; Cradle Switch

8
MULTIFUNCTIONAL INDICATOR LIGHT
There are two different functions:
Ring Indicator: Flashes when the telephone rings with an incoming call
Message-Waiting Indicator: Illuminates when a message is waiting in your voicemail system (depends
on system compatibility). The built-in Message Waiting function offers
compatibilitywithvarioussystems,whileothersystemtypesrequireoptional
extrastobettedtotheIQ333byInterquartzattimeoforder.
RINGER VOLUME SWITCH
The three available positions allow selection of OFF (no sound), LOW volume, and HIGH volume of the
telephone's ringing sound during an incoming call.
ALPHA-NUMERIC KEYPAD
The standard numeric digits are available for normal dialing. The alphabetic characters are provided to
allowfullaccesstoservicesthatrequiretheenteringofnumeralsandletters.
CRADLE SWITCH
Located in the handset cradle, this plastic lever is depressed by the handset (when placed in the cradle) to
cutofftheline.Note:Depressingthiscradlelevertoobrieywhenintendingtoterminateacallmayresult
inanaccidental"hookash"thatwillinadvertentlyplacethecallonhold.Thisisknownas"phantomcalls"
becausetheheldcallwillprobablyringagainatyourextensionwithinafewminutes(theotherpartywill
have hung up, so it will seem as if you were called by a phantom, hence the name "phantom calls"). If you
experiencethisproblem,whenterminatingyourcallpleasedepressthecradleleveralittlelongerbefore
making/receivingyournextcall(i.e.itisnotasystemortelephonefault).
ELECTRONIC VOLUME CONTROL
FortheadjustmentofthereceivevolumeoftheHANDSET,HEADSET(wiredandwirelessheadsets)or
HANDSFREE hearing level in 4 steps. Press the up and down arrow keys (v- and v+) located in the centre
ofthememorycardtoadjustthevolume.Adjustingthesecontrolsdoesnotaffectyouroutgoingvoicelevel.
See Fig 1.
RECALL KEY
For use with host telephone systems to invoke special network facilities such as Call-Hold or Call-Transfer
available in your system.
HANDSFREE/HEADSET KEY AND INDICATOR (with auto-detection)
When the HANDSFREE/HEADSET key is pressed a red indicator will glow to indicate that the HANDSFREE
mode or HEADSET mode is activated and the unit is on-line.
In IQ333EHS model, when the EHS control cable is connected to unit, its HANDSFREE/HEADSET key
function will be disabled and controlled via the wireless headset.
MUTE KEY AND INDICATOR
When pressed, it cuts off transmission from the handset, handsfree and headset microphones to allow
user privacy. The red light indicates when the mute condition is active. To release the mute condition press
MUTE again.