261A
SAVE THESE INSTRUCTIONS
(261IO) Sand Filter Pump & Saltwater System with Electrocatalysis Oxidation (14” & 16”) ENGLISH 7.5” X 10.3” PANTONE 295U 05/25/2018
English
Page 32
TROUBLESHOOTING GUIDE (continued)
LED PANEL
CODE
PROBLEM SOLUTION
LED Panel Code Flash & Alarm On (
NOTE
: Always turn off the power before cleaning and servicing).
1
. Circulation line is blocked.
2
. Incorrect inlet and outlet hose
direction.
3
. Scale on the flow sensor.
4
. Flow sensor cord is loose.
5
. Device is set and operating in
backwash, rinse or waste mode.
6
. Flow sensor failure.
1
. Dirt or scale on titanium plates.
2
. Low salt level/No salt.
3
. Electrolytic cell cord is loose.
4
. Possible electrolytic cell failure.
1
. High salt level.
2
. Possible electrolytic cell failure.
1
. LED display is off and the
“SERVICE” light is on - the system
does not power up.
•
If your unit has plunger valves, ensure that they
are open.
•
Clear your basket and cell from debris and dirt.
See “Maintenance”.
•
Depress the 6-way valve,
r
elease all trapped air
in the circulation line.
•
Check the direction of the inlet and the outlet
hose. Reverse the hoses if necessary. See “Set
Up Instructions”.
•
Clean the flow sensor, paying special attention
to the hinge. See “Maintenance”.
•
Plug the flow sensor firmly into the flow sensor
receptacle.
•
Ignore the alarm, finish the backwash, rinse or
waste operation then turn the power switch OFF
and ON again to reset the alarm.
•
Contact Intex Service Center.
•
Remove primary electrolytic cell for inspection.
Clean it if necessary. See “Maintenance”.
•
Add salt. See “Salt & Pool Water Volumes”.
•
Ensure that the cell cord is plugged firmly into
the cell housing receptacle.
•
Contact Intex Service Center. Replace the cell if
needed.
•
Partially drain the pool and refill it with fresh
water. See “Salt & Pool Water Volumes”.
•
Contact Intex Service Center. Replace the cell if
needed.
•
Household voltage is too high or too low
(+ 20%). Check the voltage is within the Range
stated on the device housing.
•
Contact Intex Service Center.
To Next Page
Loading...
