103
CD
SAVE THESE INSTRUCTIONS
Page 22
(103CD) MODEL 8111 (MODEL 8110 + MODEL 51) DELUXE SALTWATER SYSTEM (SALT IN POOL) & FILTER PUMP ENGLISH 7.5” X 10.5” PANTONE 295U
12/25/2007
SALTWATER SYSTEM OPERATION (continued)
OOPPEERRAATTIINNGG IINNSSTTRRUUCCTTIIOONNSS
5. Operating hours can be re-adjusted if necessary. Follow steps 2 thru 4.
6. The scheduled operating hours displayed on the LED readout will decrease to
zero as the unit operates. The LED shows “hours remaining” in the daily
operating cycle.
7. The green and yellow LED lights on the control panel will
disappear when the cycle has ended. The system will go
into a “Stand-By Mode” with the LED flashing
“93”. The
system automatically goes into a “Power Saving Mode”
and will automatically turn itself back on in 24 hours to
continue its daily sanitizer production.
8. The LED will be become blank after 1 hour indicating the
Saltwater system is dormant (Power Saving Mode) waiting for
the next startup cycle to begin. Press any button ( or )
to view the last LED code.
SPECIAL NOTES
• Always use a test strip to test the sanitizer level before entering or using the
pool. Standard chlorine test strips will measure the active sanitizer level in the
pool water. If the test strip indicated chlorine level is too high, wait until the
indicated chlorine level drops below 3 ppm before using the pool or
operating the saltwater system again.
• If a power outage occurs or the power cord is unplugged then the saltwater
system operating hours will have to be reset.
IMPORTANT
NEVER use the pool if indicated chlorine level is more than 3 ppm. Do not
operate saltwater system while the pool is in use or occupied.
Heavy pool usage, and higher temperatures may require higher chlorine output to
maintain proper free available chlorine residuals.
WARNING
To Next Page
Loading...
