Intex Krystal Clear 51 User Manual

Code Cause Remedy Flashing Buzzer
Low
Water
Flow or
No Flow
Low Salt
Level
High Salt
Level
103
CD
SAVE THESE INSTRUCTIONS
Page 23
(103CD) MODEL 8111 (MODEL 8110 + MODEL 51) DELUXE SALTWATER SYSTEM (SALT IN POOL) & FILTER PUMP ENGLISH 7.5” X 10.5” PANTONE 295U
12/25/2007
ALARM CODES
No sanitizer production will occur if “Low Water Flow”, “Low Salt Level” or “High Salt
Level” conditions are detected. If any of these conditions occur then the Saltwater
System will sound an alarm that indicates sanitizer production has stopped. A
buzzer will sound and a Code (see below) will keep flashing on the LED for 1 hour.
The buzzer and flashing light will stop after one hour and the Saltwater System will
go to Power Saving Mode. If this occurs then press any button ( or ) to view
the code of the original problem so that it can be corrected.
Turn off the power of the unit and follow the solutions below to solve the problem.
Turn on the unit again by following the “Operating Instructions”.
1.Circulation line
blocked.
2.Incorrect inlet and
outlet hose
direction.
3.Scale on the flow
sensor.
4.Flow sensor cord
is loose.
5.Flow sensor failure.
1.Dirt or scale on
titanium plates.
2.Low salt level / no
salt.
3.Possible electrolytic
cell failure.
1.High salt level.
• Ensure the plunger valves are
opened (if any).
• Ensure your filter cartridge, cell are
clear from debris and dirt. See
“Maintenance”.
• Release all trapped air in the
circulation line. See Filter Pump
Manual.
• Check for the direction of water
inlet and water outlet hose. Reverse
the hoses if necessary. See “Set
Up Instructions”.
• Ensure the flow sensor (especially
the hinge) is clean. See
“Maintenance”.
• Check for flow sensor loose or not
connected properly. Plug the flow
sensor firmly into the flow sensor
receptacle.
• Contact Intex Service Center for
replacement.
• Remove the electrolytic cell for
inspection and clean it if necessary.
See “Maintenance”.
• Add salt. See “Salt & Pool Water
Volumes”.
• Contact Intex Service Center.
Replace the cell if needed.
• Partially drain the pool and refill
with fresh water. See “Salt & Pool
Water Volumes”.
Ye s
Ye s
Ye s
Ye s
Ye s
Ye s
AALLAARRMMSS
• The expected life expectancy of the electrolytic cell is 3,000 hours under normal
use conditions.
• When replacing the cell, only use replacement cells having a label that clearly
states that it is a replacement cell for the Krystal Clear™ Deluxe Saltwater
System (salt in pool) & Filter Pump Model 8111.

Intex Krystal Clear 51 Specifications

General

Brand	Intex
Model	Krystal Clear 51
Category	Water Pump
Language	English