103
CD
SAVE THESE INSTRUCTIONS
Page 28
(103CD) MODEL 8111 (MODEL 8110 + MODEL 51) DELUXE SALTWATER SYSTEM (SALT IN POOL) & FILTER PUMP ENGLISH 7.5” X 10.5” PANTONE 295U
12/25/2007
LONG TERM STORAGE
MMAAIINNTTEENNAANNCCEE
1. Disconnect power cord from electrical outlet.
2. After pool is emptied of all water, disconnect the Saltwater System/Filter Pump
from the pool hose, reversing the installation instructions.
3. Air-dry the unit before storage (It may be prudent to visually inspect and clean
the electrolytic cell at this time).
4. Store the unit and accessories in a dry, temperature controlled, between 32
degrees Fahrenheit (0 degrees Celsius) and 104 degrees Fahrenheit (40
degrees Celsius) storage location.
5. The original packing carton can be used for storage.
3-Way Test Strips can test the sanitizer level as “Free Chlorine”, “pH”, and “Total
Alkalinity” levels at the same time. Directions and Use:
1. Dip entire strip into water and remove immediately.
2. Hold strip level for 15 seconds (do not shake excess water from strip).
3. Compare free chlorine, pH and total alkalinity strip pad to the color chart on
packaging label. Adjust pool water as necessary. Proper technique is important
for water testing. Be sure to read and follow the written strip instructions.
INTEX
®
3-WAY TEST STRIPS (PACKED WITH THE PRODUCT)
To Next Page
Loading...
