To Next PageTo Next PageWhy my Intex Krystal Clear 638R Swimming Pool Pump filter doesn't clean the pool?
If your Intex Swimming Pool Pump isn't cleaning the pool, adjust the chlorine and pH levels, consulting your local pool supply store if needed. Clean or replace the filter cartridge if it's dirty or damaged. For an excessively dirty pool, operate the filter for longer periods. Also, clean the strainer screen at the inlet if it's restricting water flow.
How to clear suspended matter in Intex Swimming Pool water?
If you observe suspended matter in your Intex Swimming Pool water, correct the pH level, consulting your pool dealer for advice. Adjust the chlorine level and clean or replace your filter. This issue may be due to "hard water" caused by a too high pH level, low chlorine content, or foreign matter in the water.
Why is my Intex Krystal Clear 638R Swimming Pool Pump filter not cleaning the pool?
If the Intex Swimming Pool Pump doesn’t clean the pool, adjust the chlorine and pH levels, consulting your local swimming pool supply stores for guidance. Clean or replace the filter cartridge, checking it for holes and replacing it if damaged. Operate the filter for longer periods if the pool is excessively dirty. Clean the strainer screen at the inlet.
What to do if Intex Krystal Clear 638R doesn't pump water or flow is very slow?
If your Intex Swimming Pool Pump isn't pumping water or the flow is very slow, check for clogged inlets or discharge and clear any obstructions. Look for air leaks on the intake line and tighten hose clamps, inspect hoses for damage, and check the pool water level. Replace the cartridge if there's scale or buildup. If the filter cartridge is dirty, clean it more often. Ensure the nozzle is at the upper position of the pool inlet and the strainer at the lower position of the pool outlet.
How to troubleshoot Intex Krystal Clear 638R Swimming Pool Pump filter motor that fails to start?
If your Intex Swimming Pool Pump filter motor doesn't start, first ensure the filter cord is plugged into a 3-wire outlet protected by a Class A Ground Fault Circuit Interrupter, or RCD. Check your fuse box and reset the circuit breaker; if it repeatedly trips, an electrician may be needed. Also, the motor may be too hot; allow it to cool down.
What to do if my Intex Swimming Pool Pump doesn't work?
If your Intex Swimming Pool Pump doesn't work, ensure the pool is filled to the correct water level. Clean the strainer screens at the pool inlet. Tighten hose clamps and inspect the hose for damage. Clear any sticks or leaves from the intake hose. Open the release valve at the top of the pump.
What to do if Intex Krystal Clear 638R Swimming Pool Pump doesn’t pump water or flow is very slow?
If your Intex Swimming Pool Pump doesn’t pump water or the flow is very slow, clear any obstructions in the intake hose by discharging it inside the pool wall. Tighten hose clamps, check hoses for damage, and ensure the pool water level is adequate. Replace the cartridge if there's scale or buildup. Clean the cartridge more often if the pool is excessively dirty. Ensure you install the nozzle at the upper position of the pool inlet and the strainer at the lower position of the pool outlet.
General| Brand | Intex |
|---|---|
| Model | Krystal Clear 638R |
| Category | Swimming Pool Pump |
| Language | English |
Instructions for cleaning or replacing the filter cartridge every two weeks to maintain filtration efficiency.
Procedures for preparing and storing the filter pump during the off-season to preserve its condition.
