Why are there white flakes in the water when using my Intex Water Pump?
If you observe white flakes in the water while using your Intex Water Pump, drain about 20 to 25% of the pool water and add fresh water to decrease the calcium hardness. Inspect the electrolytic cell for scale buildup and clean the electrolytic cell if necessary.
Why does my hair turn green when using Intex Krystal Clear CS15110 Water Pump?
If you have green hair, drain about 20% of the pool water and add fresh water to decrease the copper ion concentration below 0.2ppm. Add aluminum sulfate: 1000 liters water need around 2g (1000 gals need 0.27 ounce) or aluminum potassium sulfate: 1000 liters water need around 3g (1000 gals need 0.4 ounce) to pool. Use ‘Ultra-Swim’ shampoo, or shampoo containing chelating agents.
What to do if there's chronic low water level in my pool with Intex Krystal Clear CS15110?
If you have a chronic low water level in your pool while using an Intex Water Pump, repair any rips or holes in the pool liner or hoses with a patch kit. Finger tighten all drain valve caps.
How to remove sediment on pool bottom with Intex Krystal Clear CS15110?
If there is sediment on the pool bottom while using your Intex Water Pump, use an Intex pool vacuum to clean the bottom of the pool.
How do I remove surface debris from my pool using an Intex Krystal Clear CS15110 Water Pump?
If there is surface debris in your pool while using an Intex Water Pump, use an Intex pool skimmer.
What does it mean when the LED panel code flashes and alarm sounds on my Intex Krystal Clear CS15110 Water Pump?
If the LED panel code is flashing and an alarm is on for your Intex Water Pump, check the following: * If your unit has plunger valves, ensure that they are open. * Clear your basket and cell from debris and dirt. * Check the direction of the inlet and the outlet hose; reverse the hoses if necessary. * Clean the flow sensor, paying special attention to the hinge. * Plug the flow sensor firmly into the flow sensor receptacle. * Remove the electrolytic cell for inspection and clean it if necessary. * Add salt if the salt level is low or there is no salt. * Ensure that the cell cord is plugged firmly into the cell housing receptacle. * Partially drain the pool and refill it with fresh water if the salt level is high. * Check the household voltage is within the range stat...
Read and follow all instructions carefully before installing and using this product.
Key warnings and cautions for safe operation, installation, and product handling.
Visual identification of all components included with the sand filter pump system.
Exploded view diagrams illustrating the assembly of product components.
Table listing parts by reference number, description, and spare part number.
Instructions for installing pool outlet strainer and inlet nozzle valve assemblies.
Detailed technical specifications for the sand filter pump and saltwater system.
Procedures for loading sand and installing the 6-way valve.
Explanation of valve positions and their functions for filtration and maintenance.
Guide to operating the saltwater system, including setting hours and boost cycles.
Procedures for cleaning motor pre-filter, flow sensor, electrolytic and copper cells.
Instructions for preparing the system for long-term storage or winter.
Solutions for common problems like motor failure, low flow, and leaks.
Details of the product's limited warranty terms and conditions.
Contact information and locations for Intex service centers worldwide.
General| Model | CS15110 |
|---|---|
| Voltage | 110-120V |
| Suitable for pools | Above Ground Pools |
| Pump Flow Rate | 1500 GPH |
| Cord Length | 25 feet |
| Filter Type | Cartridge |
| Inlet/Outlet Size | 1.5 inch |
To Next Page