344
PO
S AVE THESE INSTRUCTIONS
(344PO) SPA (JET + BUBBLE) ENGLISH 7.5” X 10.3” PANTONE 295U 07/20/2019
English
Page 17
OPERATION (continued)
Adjustment Buttons:
Press the increase or decrease buttons to adjust the desired function
settings. Press and hold the button will rapidly increase or decrease the numbers.
Celsius/Fahrenheit Toggle button:
The temperature can be displayed in either Fahrenheit
or Celsius. The system’s default is Celsius.
NOTE:
The default temperature is 68°F (20°C). Temperature adjustment ranges from 50°F
(10°C) to 104°F (40°C).
NOTE:
The spa control panel is resistant to water, but it is not designed to be completely
submerged. Do not put the control panel in the water. Submersion could cause water to enter
the panel causing damage to the electronics.
LED Display:
Once plugged in the LED displays the current water temperature automatically.
If the control panel
(3)
is not placed on the control base recessed channel, the LED display
will go blank after 5 minutes. Press any button to resume the control panel.
K: Decrease Button
L: Increase Button
M: Celsius/Fahrenheit Toggle Button
N: LED Display
SPA CONTROL PANEL
K
L
N
M
Heater Function Setting Examples
Temp set
at (
o
C/F)
HST HDT
Action
40/104 000H 000H
HST & HDT functions are off. Heating system has to be activated manually
by pressing ( ) button. See “Spa Control Panel” section for details. The
heater will continuously heat until the temperature is reached and then hold
at that temperature.
40/104 000H 005H
Turn the heater on and set a run time at which point the heater will turn
itself off. The heater will continuously heat until the temperature is reached
and then hold at that temperature until the 5 hours run time has expired,
regardless if the water temperature has reached 104°F /40°C or not.
40/104 012H 005H
Turn the heater on some time into the future to a set temperature and set a
run time at which point the heater will turn itself off. The heater will start after
12 hours and continuously heat until the temperature is reached and then
hold at that temperature until the 5 hours run time has expired, regardless if
the water temperature has reached 104°F /40°C or not.
40/104 012H 000H
Turn the heater on some time (in hours) into the future to a set temperature.
The heating system will start after 12 hours, and continuously heat until the
water reaches 104°F /40°C and then hold at that temperature. When the spa
water temperature drops 1.8-3.6°F (1-2°C) below the set temperature the
heating system will restart. When the fl ame icon on the display is red, the
heating system is activated. When the fl ame icon turns green, the water is at
the set temperature. The heating system is at rest and the fi ltration system
will continue working nonstop.
To Next Page
Loading...
Need help?
General
