344
PO
S AVE THESE INSTRUCTIONS
(344PO) SPA (JET + BUBBLE) ENGLISH 7.5” X 10.3” PANTONE 295U 07/20/2019
English
Page 32
If there is a need to replace the fi lter motor (for qualifi ed technician only), follow below steps to
disassemble it:
IMPORTANT:
You must drain out any remaining water inside the piping system of the control
base before replacing any parts.
Tools required:
One adjustable wrench and one Philip screwdriver.
NOTE:
The “special wrench tool” is included with the new fi lter pump motor replacement and not
with the spa set.
FILTER PUMP MOTOR DISASSEMBLY
123
456
To Next Page
Loading...
