344
PO
S AVE THESE INSTRUCTIONS
(344PO) SPA (JET + BUBBLE) ENGLISH 7.5” X 10.3” PANTONE 295U 07/20/2019
English
Page 18
OPERATION (continued)
Jet Nozzle Adjustment
The amount of water and pressure coming out from the jet nozzles can be adjusted
by turning the jet nozzle rim clockwise (maximum water output), counterclockwise
(low water output) or anything in between.
Closing one or 2 jet nozzles will divert more water pressure to the other jet
nozzles.
NOTE:
Keep the spa control panel within 5m (16ft) range of the control base to ensure good
wireless transmission signal.
-
+
Function ON OFF Information shown on LED display alternates between
Remaining fi lter pump time and water temperature
Remaining HST time and water temperature
Remaining HST time and water temperature fi rst.
Then remaining HDT time and water temperature.
Remaining HDT time and water temperature
Water temperature and remaining sanitation time
Water temperature and remaining sanitation time
WARNING
NEVER use the spa if indicated water temperature is more than 40°C (104ºF).
To Next Page
Loading...
Need help?
General
