344
PO
S AVE THESE INSTRUCTIONS
(344PO) SPA (JET + BUBBLE) ENGLISH 7.5” X 10.3” PANTONE 295U 07/20/2019
English
Page 9
SET UP (continued)
Infl ation
Infl ate the Spa Tub Wall
1.
Take out the ground cloth
(19)
and spread it over the cleared area. Then spread out the spa liner over
the ground cloth and point the drain valve towards a suitable draining area.
NOTE:
Spread the ground cloth with the bubbles facing down over the cleared area where you intend
to setup your spa.
2.
Flip up the control base side cover
(36)
to reveal the air blower infl ation outlet. Pull out the latch to open
the cover, insert the hose adaptor
(24)
with hose and reattach the latch to the hose adaptor to secure it
in place
(see drawing 3)
.
3.
Unscrew the air valve cap on the spa tub to reveal the
stem in the up position for infl ation. Insert the other end
of the infl ation hose
(7)
into the valve and turn to the
right to lock it in position
(see drawing 4)
.
3
1
2
3
4
5
4
7
1 2
5
4.
Press the
button to turn on the control panel.
Press the
button to infl ate the spa tub wall for 8 to
10 minutes until it is fi rm to the touch but not hard
(see drawing 5 & 6)
.
IMPORTANT:
Do not over infl ate or use high pressure
air compressor to infl ate.
5.
Press the
button again to turn it off.
To Next Page
Loading...
