VIDEO MODE MENU
1. MOVIE SIZE: sets the video recording’s pixel dimensions and frame rate. Choices are 1920x1080 (30fps),
1280x720 (60fps) and 1280x720 (30fps). Factory default resolution is 1920x1080 (30fps).
2. WHITE BALANCE: adjusts color balance for various lighting situations.
a) AUTO: normal exposure/factory default.
b) DAYLIGHT: adjusts imagery to cooler (blue/cyan) color balance for warm outdoor lighting.
c) CLOUDY: adjusts imagery to warmer color balance for scenes with cool outdoor lighting.
d) FLUORESCENT: adjusts imagery to warmer color balance for scenes with uorescent lighting.
e) TUNGSTEN: adjusts imagery to cooler (blue/cyan) color balance for scenes with warm
(red/yellow) indoor lighting.
3. VIDEO QUALITY: sets video quality between SUPER FINE, FINE and NORMAL compression. Factory
default is SUPER FINE.
4. STABILIZER: sets the electronic image stabilization to ON or OFF. Stabilizer function is only eective to
reduce only very small vibration such as during video recording while walking with the camera. Factory
default is ON.
5. VOICE REC: turns microphone ON to record sound during video recording or OFF for no audio. Factory
default is ON.
6. LOOP RECORDING: sets the camera to record a video clip for a selected time length in minutes and to
continue recording video clips of the same time length one after another unless operator stops recording
by pressing the SHUTTER button. Choices are OFF, 1 min, 3 min and 5 min. Factory default is OFF.
7. MOTION DETECT: sets camera to start recording video automatically when motion is detected in
its eld of view. Video will be recorded for 5 seconds and stop if no other motion is detected. Factory
default is OFF.
8. SLOW MOTION: allows a “slow motion” video clip to be created without the need for post production
in a video editing software. Factory default is OFF.
9. TIMELAPSE: sets the camera to record video clips with delays between each frame corresponding to
selected time interval in seconds or minutes. This produces a time lapse video without the need for post
production. Setting choices are OFF, 3 sec, 5 sec, 10 sec, 30 sec, 1 min and 3 min. Factory default is OFF.
10. TIMELAPSE DURATION: when timelapse function is activated this function can be accessed to set
the length of the timelapse video. Choices are OFF (Unlimited), 3 min, 5 min, 10 min, 15 min, 20 min,
30 min and 60 min. Factory default is OFF.
11. DATE STAMP: sets the date only or date and time on the video clip which is visible during playback.
Setting choices are OFF, DATE, and DATE/TIME. Factory default is OFF.
While in video mode, press the MENU button to enter
menu selection screen. Use the UP or DOWN navigation
buttons to highlight a menu item and press OK button
to access and adjust or activate various video functions.
11
DUB
To Next Page
Loading...
Need help?
General
