Invacare MK5 NX - User Manual

Questions and Answers

J
John ClarkAug 12, 2025
What to do if Invacare Controller wheelchair does not respond to commands?
- C
  Cory CruzAug 12, 2025
  If your Invacare Controller wheelchair isn't responding, there are several possible causes. First, ensure the battery terminals are clean. Check all joystick connections. Also, inspect the wiring harness for bad connections or a blown fuse, and replace the wiring harness if needed. Finally, make sure the battery charger is unplugged from the joystick.
S
shepherdcindyAug 15, 2025
Why does my Invacare Controller wheelchair veer to the left or right?
- G
  gilesmichaelAug 16, 2025
  If your Invacare Controller wheelchair veers to the left or right on a level surface, the joystick may need calibration. Calibrate the joystick using a programmer. If calibrating the joystick doesn't solve the issue, consider replacing the joystick.
J
johncervantesAug 19, 2025
What to do if Invacare Controller displays Error Code E03 or E04?
- D
  Danielle StevensonAug 19, 2025
  If your Invacare Controller displays Error Code E03 or E04, indicated by 3 or 4 joystick LED flashes, here's what you can do: First, ensure the motor lock levers are engaged. Next, check all motor connections to make sure they are secure. Ohm out the brake connection and ensure that the reading is within the normal range of 40-80 Ohms.
M
mooremichelleAug 23, 2025
Why is my Invacare Controller wheelchair slowing down?
- W
  William HernandezAug 25, 2025
  Your Invacare Controller wheelchair might be slowing down because the elevating seat is elevated. This feature includes a speed reduction safety mechanism that reduces the wheelchair's speed by 80% when the seat is in a raised position. To resolve this, return the seat to its lowest position.
A
Amy HernandezAug 27, 2025
What to do if Invacare Controller seating system is not functioning?
- W
  wwilliamsAug 27, 2025
  If the seating system on your Invacare Controller is not functioning correctly or is working intermittently, consider the following: First, charge the batteries. Check all electrical connections to ensure they are secure. Replace the wiring harness if there is a blown fuse. If the seat has been under a heavy load for a long time, allow the electronics to cool down for at least 3 minutes with the power on, without using the powered seating functions. Check all motor connectors and ensure that the motor locks are engaged.
T
Timothy WallaceAug 30, 2025
What to do if Invacare Controller displays Error Code E02?
- R
  Rebecca JohnsonAug 31, 2025
  If your Invacare Controller displays Error Code E02, indicated by 2 flashes of the joystick LEDs, the batteries likely need to be charged. Charge the batteries to resolve this issue.
A
April RussellSep 4, 2025
What to do if Invacare Controller wheelchair drives at full speed when seat is elevated?
- H
  heidialexanderSep 4, 2025
  If your Invacare Controller wheelchair drives at full speed when the seat is elevated, check all connectors for faulty electrical connections.
C
Christy FitzgeraldSep 7, 2025
Why is there no LED on my Invacare Controller joystick?
- G
  gregg52Sep 7, 2025
  If there are no LEDs lit on your Invacare Controller joystick, check all joystick connections to ensure they are properly connected. If you find any damage, replace the joystick. Additionally, inspect the wiring for corroded wiring or connections and replace the wiring harness if corrosion is present.