In winter, absence function can keep the indoor ambient temperature above 0ºC to avoid freezing.
Note: Absence function is only available in heating mode and it will be exited when switching mode or setting sleep function.
(1).
Lift the cover along the direction of arrow (as shown in Fig 1①).
(2).
Take out the original batteries (as shown in Fig 1②).
(3).
Place two 7# (AAA 1.5V) dry batteries, and make sure the position of “+” polar
and “ -” polar is correct (as shown in Fig 2 ③).
(4).
Reinstall the cover (as shown in Fig 2④).
Fig.1 Fig.2
Notes:
①
.
The remote controller should be placed 1m away from the TV set or stereo sound sets.
②
.
.egnar gniviecer sti nihtiw demrofrep eb dluohs rellortnoc etomer fo noitarepo ehT
③
.
If you need to control the main unit, please point the remote controller at the signal receiving window of the main unit to improve
④
.
When the remote controller is sending signal, “ ” icon will be blinking for 1 second. When the main unit receives valid remote
⑤
.
If the remote controller does not operate normally, please take the batteries out and reinsert them after 30 seconds. If it still
can't operate properly, replace the batteries.
⑥
.
When replacing the batteries, do not use old or different types of batteries, otherwise, it may cause malfunction.
⑦
.
.seirettab eht tuo ekat esaelp ,emit gnol a rof rellortnoc etomer eht esu t’now uoy nehW
the receiving sensibility of main unit.
control signal, it will give out a sound
To Next Page
Loading...
Need help?
General
