What to do if indicator lights won’t go off on inventum IVW6008A Dishwasher?
If the indicator lights on your Inventum Dishwasher remain on after the cycle, it may be because the On/Off button hasn't been released yet.
How to fix inadequate water supply in Inventum Dishwasher?
To resolve an inadequate water supply in your Inventum Dishwasher: - Ensure the tap is fully open and that there are no obstructions in the water mains. - Close the tap, detach the input hose, and inspect it for clogs. - Restart the dishwasher. If the issue persists, contact Inventum's service department.
What to do if my Inventum Dishwasher contains water after the program finishes?
If your Inventum Dishwasher has water in it after finishing a cycle, the drain hose might be clogged or twisted. Ensure that the drain hose is not clogged or twisted. The filters may also be clogged, so clean them. Wait until the program is finished. A buzzer sounds five times and the ready indicator is on when a program is finished.
How to prevent food waste left on dishes in my Inventum Dishwasher?
To prevent food waste from remaining on dishes in your Inventum Dishwasher, ensure the appliance is loaded correctly so the spray arms can reach all dishes. Check that the cutlery basket isn't too full and that dishes aren't placed too close together. Also, use a sufficient amount of detergent and select a program suitable for the load. Clean the spray arms and filters, ensure filters are correctly placed, and check that the water drain pump isn't clogged.
How to get my dishes dry in Inventum Dishwasher?
If dishes aren't drying in your Inventum Dishwasher, the selected program may not include a drying cycle, so choose a program that does. Also, the level of rinse aid consumption might be set too low, so adjust it. Finally, avoid unloading the appliance too quickly after the program finishes; wait a few minutes.
Why won't the dishes dry in my inventum IVW6008A?
Dishes may not dry in your Inventum Dishwasher if: - A program without a drying cycle was selected. - The rinse aid dosage is too low. - The dishes are unloaded too quickly after the cycle.
What does error code F1 mean on my Inventum Dishwasher?
Error code F1 on your Inventum Dishwasher indicates that the safety for water overflow is activated. Disconnect the mains plug and close the water tap.
Why does my inventum IVW6008A stop during a wash cycle?
Your Inventum Dishwasher might halt mid-cycle due to: - A power failure. - A water supply issue. - The program being paused.
Why does detergent remain in the Inventum Dishwasher's reservoir?
Detergent residues in the Inventum Dishwasher's reservoir may occur if the reservoir was damp when filled. Make sure that you fill the detergent reservoir when it is dry.
Why does my inventum IVW6008A stop mid-cycle?
Your Inventum Dishwasher might stop during a program due to a power failure, so ensure there is power. It could also be due to a water inlet failure, so ensure there is a water inlet supply. The program may have been paused, so start the program to resume the cycle.
General| Current | 16 A |
|---|---|
| Connected load | 1900 W |
| AC input voltage | 220 - 240 V |
| AC input frequency | 50 - 60 Hz |
| Power consumption (off) | 0.5 W |
| Water consumption per cycle | 12 L |
| Energy consumption per cycle | 0.9 kWh |
| Drying class | A |
| Annual water consumption | 3360 L |
| Annual energy consumption | 258 kWh |
| Cycle time | 187 min |
| Noise level | 47 dB |
| Drying system | Condensation |
| AquaStop function | Yes |
| Delay start (max) | 9 h |
| Dishwashing programs | Eco, Intensive, Pre-wash, Quick, Rinsing + drying |
| Number of place settings | 12 place settings |
| Number of washing programs | 5 |
| Number of temperature settings | 4 |
| Door color | Not applicable |
| Water fill | Cold |
| Cord length | 1.8 m |
| Control type | Buttons |
| Product size | Full size (60 cm) |
| Tub material | Stainless steel |
| Inlet hose length | 1.47 m |
| Outlet hose length | 2 m |
| Appliance placement | Fully built-in |
| Control panel color | Gray |
| Cutlery compartment type | Basket |
| Package depth | 661 mm |
| Package width | 644 mm |
| Package height | 851 mm |
| Package weight | 40000 g |
Weight and Dimensions| Depth | 550 mm |
|---|---|
| Width | 598 mm |
| Height | 820 mm |
| Weight | 38000 g |
| Installation compartment depth | 570 mm |
| Installation compartment width | 600 mm |
To Next Page
