Inverter Pulsar - Procedure

CLEANING AND CARE
24
Pulsar extractor fan | Installation and operation instructions
NOTICE: The fan must not be sprayed or
immersed in water.
Cleaning agents:
NOTICE: The Pulsar has a plastic surface that is sensitive
to scratches. Do not use cleaning agents containing sand,
soda, acid or chlorine to avoid damaging the surface.
Commercial liquid soap in warm water can be used for
cleaning.
Procedure:
► Disconnect the power supply.
• AC 230 V: Disconnect the connection at the switch
of the Pulsar. The switch is located on the left side of
the fan housing. Push it down to the 0 position.
• DC 12 V: Interrupt the power supply at the mains
fuse or at the external switch.
► Reach behind the fan unit with both hands.
► Remove the fan unit from the fan housing by pulling
it forwards.
Hold the fan unit rmly so that it does not fall to
the oor after removal.
► Carefully insert the fan unit into the guides (red
arrows) on the fan housing.
Do not tilt the fan unit when inserting it so as
not to damage the contacts.

An audible click conrms that the fan unit is correctly
inserted.
► Clean the wall sleeve, the fan housing and the fan unit
with a damp cloth.
The fan is cleaned directly at the fan unit, it
must not be dismantled.
!
!
!
1
3
2